@giubbe-de-giubbix hese are dead zones problem, and as of now, there is no way to manage deadzones on recalbox... so i's unsolvable for the time beeing

@YuOminae As far as I understand, the problem of ScummVM which doesn't boot if your controller is off should be solved with Recalbox 6.1.

Why it doesn't work with your controller on, I have no idea. But the mouse should be emulated with the left joystick of your controller.

I don't really know how the PS3 controller is supported ... can it be a side-effect of it ?

Oui il s'agit du dosbox.cfg ds le rep du jeu, en fait ça interagi bien avec la souris mais pas sur le joystick merci qd mm

@substring said in Appp to use android phone as mouse and/or keyboard in recalbox:

@niculinux what's so bad with the virtualgamepad ?

Absolutely not! Just to enquiry; if some exists, even with possibility to use bluetooth, so without going on internet ☺☺

Ok, thanks. Seems I have to wait :)

@giubbe-de-giubbix

you are welcome

@cochise YESS super ,bon jeux^^

usbhid.mousepoll=2 to boot/cmdline.txt
solved my problem. Now responding nicely.

@acris i did, didn't appear to make much difference....

@andré-alcover-rodrigues so you have a SEMICO USB keyboard. It has 2 possible events. You should start evtest and test bith to see which one is responding when you're typing on it. Write down its name, and find to which /dev/input/by-id it corresponds to

Next, in the moonlight.conf, simply add that /dev/inout/by-id/blablabla that worked

Le protocol de transmission entre une souris USB et une souris sérielle RS232 est différent, et donc déja là il se peut un problème. De toute façon, je doute que tu arrive avec une souris USB, aussi à cause du protocol. Les souris sérielles attendent un voltage différent de 5V. Alors il ya des Chips qui transforment +5V en - et + 10V. Comme le Max232. Si tu essai avec un câble USB - Sériel qui comporte ce chip, ça doit d'abord fonctionner sur une prise USB de ton PC. Après tu peut tester sur PI.

@reiserfs nope you can't

Just set recalbox to autostart to kodi ;)

Hey guys. No offense but this is a solved, English thread. :)

So is this why the changes in the RetroArch confg are never saved for the P2 bindings? Do I need to change that line in the Python script to remedy this? If so, where do I find it?

It doesn't matter overly now though - I've manually set the emulators for the few games that can get by on the other emulators (despite the save game location being different to proper "save" folders!). I've yet to decide whether to use this method or my manual config file.

I think if SNES 9x could be setup to only enable multitap when 3+ controllers are connected, it would be perfect. That and the save locations for the other emulators.

Other that that my setup is god to go. Thanks guys :-)

Can't you just copy an sdcard with already fresh installed system?