@dapaze said in Can't connect from mac using SMB:

I'm using the latest 7.1.1 download, and I'm trying to connect to recalbox via SMB://recalbox so I can use the web manager tool to transfer roms, and it won't connect using these steps:

Looking at the Network settings in Recalbox, both the STATUS and IP ADDRESS are showing NOT CONNECTED. When I try connecting to recalbox on my mac using smb://recalbox, I get an error... "There was a problem connecting ..."

I double checked that recalbox and my mac are sharing the same wifi.

thanks my issue has been fixed.

Make sure you're using "SSH" and port 22. Putty default connections are for COM port connections.
Have you tried simply using "recalbox" instead of an IP?

Last, can you try either an alternate WiFi router such as your cell phone? Turn on moblie hot spot, connect your PC to your hotspot (might want to try some simple network tests to confirm it's working) then connect your RB to your phone?
Alternatively, you can use a RJ45 ethernet cross-over cable, but that's going to involve a lot more work using DOS commands like ARP.
Either of these will eliminate network rules that may be blocking the connection.

@ordovice
Thank you
enabling ERTM in the recalbox.conf file and switching the bluetooth driver to offiziel did work.

Thanks

My Controller looks exactly as shown in this older topic: link
He said in german that he could connect it, but mine won't.

Following the steps in the tutorial fixed my auto reconnect issue. Thanks.

Bonjour,

Je relance ce topic car j'ai exactement le même problème. J'ai flashé un dd avec la 6.1.1, le premier boot se passe parfaitement puis le second reste bloqué a l’écran de démarrage.
En mode verbose, j'ai le message d'erreur suivant: xinit: giving up xinit: unable to connect to x server

J'utilise un HP hp t610 thin client - APU T56N AMD avec carte graphique Radeon HD 6320

J'ai essaye de flasher la version x86 et x64, même résultats...

@shira please open a new topic

Je ne sais pas si tu as eu ta réponse, mais il ne faut pas oublier que ton clavier sera par défaut en mode QWERTY, il faut y songer quand tu entre ton mot de passe.

@oluminion set the manaver to version 2, make sure it's started in the advanced settings in es

@elias-palma that's unless understand your errir message in portuguese lol

The xu4 kernel won't happen before months. I started working on it, there are too many changes involved regarding emulators and kodi

Fixed it after all, with a little fiddling around the router's settings. Apparently, it had been conflicting with an older version. We changed ISPs recently, but the name was the same.

@alexander-tolstykh that's always a bad idea to unplug the power without shutting it down, like any operating system, you may corrupt your data. And yes, because wifi management has been reviewed to allow network share over wifi, now you must shutdown your system properly to keep your wifi settings.

@Sergio-Villanueva
If you have a fan that just switch on over a certain temperature, this fan will switch off automaticly by hard or soft shutdown. I just planned to set this up in the next days.

@chris-von-görstinger read the changelog and the blog ... Pi3 internal BT supported since 4.1