Thanks @paradadf ! I will wait :)

@voljega @substring thanks guys I’ll wait the update and use another controller in the meantime

Hi again

I think I have figured out the problem for myself.

By pure chance (and the fact that I was looking at the older 1979-1981 games), each of the Mame ROMs I tried while setting up Recalbox only ever had a single set of controls.

Although the TAB menu includes and allows modification of P2 controls these are only for use when the DIP switch settings are for a Cocktail cabinet.

Looks like on earlier games I have to live with using a single set of controls!

Steven

@edumayer
Je pense que non. Je n'en vois pas le sens. Si tu installe un hub alimenté tu pourras ajouter 2 Zero delay en plus, si les 4 existant ne sont pas suffisant.

@keith-mason this just depends on games. On super mario bros or alex kidd in miracle world, you can somehow "control" the jump while in air

please update last version of recalbox. No support for old version.

I have run into a problem with the C64 emulation specifically many intros and trainers ask for the run/stop key to exit and play the game - and I cannot find a key that accomplished that = either on a physical keyboard or on the virtual one (I can see two r/s keys on page two of the virtual kb, but nether does anything).

I might be missing something obvious - but so far a dead end for me.

sTeVE

@substring
That´s what I ended up doing, after a lot of trying I successfully got what I wanted by editing gamecon_gpio_rpi.c and rebuilding the driver.
So now I have 4 gamecon gpio controllers, POWER, RESET and LED!

PIN01 | 5V PIN06 | GROUND PIN19 | CLOCK PIN23 | LATCH PIN07 | DATA3 (NES1) PIN26 | DATA4 (NES2) PIN29 | DATA5 (SNES1) PIN31 | DATA6 (SNES2)

The code replace in gamecon_gpio_rpi.c:

/* GPIO pins 0, 1, 4, 7, 29, 31 */
static const int gc_status_bit[] = { 0x01, 0x02, 0x10, 0x80, 0x20, 0x40 };
static const int gc_gpio_ids[] = { 0, 1, 4, 7, 29, 31 };

@cotox enjoy fds :)

@luke no prob, glad it works for you also !

@gigante154 you only need HK for P1.

I already gave you a link to another thread where that has been explained.

Do you configure your gamepad in emulationstation menu > gamepad options ?

Thx for clearing that out Subs.
i'll just continue setting up my cabinet with future vision for setting up ratio per game when 4.1 gets released .(any idea about a timeframe for that )

Further I would like to thank you guys for this great frontend.
I think the simplicity in controlling the frontend is what makes me choose recalbox over retropie .(less is more) and must not forget a great "favorites" system is a must as I use that a lot on my windows based cabinet (Gameex).

/Benjamin

I added the line to load my fba_libretro.cfg file, but it doesn't work.

Also, I've tried to configure retroarch (I move through the menu using a keyboard), but when I try to map a button from the joystick, it doesn't recognise it. Do I need to press anything before trying to map it (Enter doesn't work).

Thanks again.

hey ! the usual HK+start combination has been mapped in recalbox 4 to exit mupen