@Scavy merci j'ai un consol playtation 3
et e suis pas dans le bon forum
merci

Hello @jona1492
On the help page of the site, since the 1.5 version, it's written to type CUSTOM1=2 (CUSTOM1=4 seems to be for former versions).
Could you try ?
Nota : no link to websites contening stuff under licence. Thanks 🙂

I finally managed to figure it out. The reason why the above config files don't have any effect is simple, but not obvious: There are two variants of the Moonlight front-end: moonlight-embedded and moonlight-qt. The files in /recalbox/share/system/configs/moonlight are for moonlight-embedded, but Recalbox uses moonlight-qt on RPi4. Therefore, another config file is used which is located at: /recalbox/share/system/.config/Moonlight\ Game\ Streaming\ Project/Moonlight.conf.

It was not clear to me how to modify the config to switch to 1080p. The file is normally managed through the Qt front-end and not directly edited. So I installed moonlight-qt onto another Linux box, applied the settings through the UI and checked the config file. There required settings are part of the [General] section:

[General] width=1920 height=1080 fps=60

Porting the settings over to my RPi4 Recalbox finally made it stream my 1080p desktop in 1080p! Looks much better now!

@avepym hello
Une mise à jour depuis la V7 n'est pas possible. Trop de modifications depuis ces versions. Prends la dernière en cours et installe la (prends bien la version GPi case + Pi0)

Since you are mentioning WAN (and not LAN):

AFAICS the current Moonlight.sh script will always assume that the machine is on the local network and append .local to the host name. According to the Recalbox wiki, the Moonlight.sh script needs to be modified to work with IPs instead of hostnames. The Moonlight wiki contains an extensive guide for setting up game streaming over the internet. The guide recommends to pair the server while still being on the same network. If this is an option, it is probably easier than modifying Moonlight.sh. Once that's done, you can manually adjust the config files with the public IP of your server and set up the port forwarding if necessary.

@Pecee1946

🙂 Thanks! but if I could press F7.. I wouldn't need the virtual keyboard.

Hi all,

same for me, I just tested RecalBox for the first time on an rpi5 and I am very amazed! Thank you 🙂

The only thing missing for me is also mamemess-current/ mame_libretro. Indentically, I now also have the libretro core in /usr/lib/libretro/mame_libretro.so, but I cannot figure out how to select it. I looked at a few ES config files, but so far no luck. @barleyguy could you point us to the right config file(s)?