@locomexicano68
Look at the Line
idVendor=054c, idProduct=0268, bcdDevice= 1.00
in your "dmesg-Log"

On another Board it says that this is a SHANWAN PS3 GamePad even if it say "Product: PS3 Controller" and "Manufacturer: Sony" in the Log-File

So in the "recalbox.conf" File you must change the Line "controllers.ps3.driver=official" from "official to "shanwan"
and set "controllers.ps3.enabled=1"
You will find these Settings in the "recalbox.conf" File under "D1 - PS3 Controller"

If you don't know, you will find the "recalbox.conf" File in
/recalbox/share/system/.

Infos about PS3 Controller Drivers in Recalbox:
https://wiki.recalbox.com/en/tutorials/controllers/controllers/ps3-controllers-drivers

Hello @NahuGravelord
not use recalbox manager , you need to verify with bios manager inside emulationstation
https://www.youtube.com/watch?v=JskTpPJdoJM&list=PL2oNQ0AT7fx2ExiSNrfHUzga5GnogI4sh&index=25

@space81 https://forum.recalbox.com/topic/19443/contrôles-gpio-sur-dosbox

@hitmaker If you use the joysticks on PS4, you need to reset them first. Another possible solution in the emulationstation control setting is to "forget" the already paired controls (I can not remember the right term in English now, and the translator may affect the translation).

@trantornator I figured out the problem. Extensions were Z80 not z80.

Problem solved.

Hmm Ntfs is very very slow. You need MBR boot not GPT boot.
You need format fat32 for recalbox 4.0.2.

But if it s ok with your ntfs hard drive very good.

You need to enable, may be, core per game option in retroarch menu.