Posts made by NoAttitude

@Substring what about in "default mode" ? Is it possible to hide some menus from this mode?? Thanks

Bartop mode is working great, but I would like to add in and configure the controllers later, but the "controllers settings" menu is missing in this mode.
Any possibilities to unhide the "controllers settings" menu in "bartop" mode? Thankyou so much T--T

I've tested out the GPIO buttons from https://github.com/recalbox/recalbox-os/wiki/GPIO-controllers-(EN) And they worked out well except for the hotkey button (can t be use ) , but instead the hotkey is tie with the "select button"

Does this mean that the hotkey button in the gpio pin is not nessesary? Thankyou

@Substring thanks a lot

@lackyluuk Too bad for me ... I can t read German... I m a Thai >__< anyway, thankyou for your reply.

@xtreemsurf Your answer has cleared my doubts.. thanks a lot...!!! :
)

@voljega No .. it does nt work T-T

I hope I am correct this time...

@voljega

I must be confused here. You said "pin 5" (GPIO3) goes on switch " I " ( Right pin on the switch ) and nothing on switch " 0 " (Left pin on the switch ) Which part I am missing here ?? Thankyou

@voljega said in Rocker switch on GPIO pins?:

@NoAttitude no as I said pin5 goes on switch I and nothing on switch 0

This is it??

@voljega

Is this drawing method correct??

@voljega said in Rocker switch on GPIO pins?:

@Substring one for ground, one for I, one for 0 si you can conbect your switch as closed on either 0 or I

Do u mind drawing a simple diagram for me ?? T---T I m so confused right now

@Substring it s for the on and off switch.. thankyou

Is it possible to use this 3 pins rocker switch with LED light on the GPIO pins??

If it s possible, how am I suppose to wire it ?? I m a super newbie on this. Can you guys help me draw out a simple diagram on how to wire this to my pi ??

I ve read this link https://github.com/recalbox/recalbox-os/wiki/Add-a-start-stop-button-to-your-recalbox-(EN) but it does nt mention anything on this 3 pins rocker

Thankyou so much

Hi, I m a newbie here and I 'd like some help from you guys please... I ve just tried to install a blue 12V LED switch to the GPIO pin as the attach picture shows.

Once I plug the USB adapter into the pi , LED lights up and it boots automatically without me pressing the switch. I tried to shutdown, the LED went off normally. As long as the USB adapter is plugged into the pi, I can turn on the pi with the switch but once I unplug the adapter and plug it back, it automatically turn on again without me pressing switch.

The power is turn on with the USB adapter instead of the switch.

Is there a way to start up my pi with just the LED switch, not the usb cable? Or I have wired anything wrong?
PS. sorry for my bad English and thanks in advance