ARGON 1 Cooler control script

[mkoff]

Hi. There is no way to run the script over SSH. Maybe there is some other way to connect it?

curl https://download.argon40.com/argon1.sh | bash

[dstroy]

@mkoff
There is no way cause it's not the right script get this one :

curl https://download.argon40.com/argonone-setup-recalbox.sh | bash

yours is for raspbian oses like.

[Pitch64]

To complete the answer for anyone else, ssh to your rpi4 and copy the command from @dstroy's post. This will install all the necessary to have the fan and shutdown to work. I did it and works fine. I just had to reinstall it after the upgrade from 7.0.0 to 7.0.1 to have it working back, but it's a small issue and needs to be confirmed if others got it too

[mkoff]

I want to test the script. How can you load Recalbox 7 to raise the temperature above 55 degrees?

[mkoff]

curl https://download.argon40.com/argonone-setup-recalbox.sh | bash
Its Working. Heated with Dreamcast "Exhibition of speed" + Warm cloth on top

[Secamfr]

@mkoff You can edit parameters in this file :

/share/system/argononed.conf

[mkoff]

@Secamfr
I found this. Thanks!

[dstroy]

@Secamfr
if you are not used to vim/vim or other nix editor you can use an interactive config command via typing

argonone-config in your terminal after getting on pi via ssh after having installed & run the install script