Remote Control Recalbox - device required?
I've tried to make a remote control work with this manual Infra red remote control on the Recalbox (EN), but it doesn't work.
Everything works until i need to enter the line mode2 -d /dev/lirc0 -r -m.
It shows the --raw option requires a --device instead of the numbers shown in the manual.
What should i do to make it work?
mode2 --device /dev/lirc0 -r -m? Which board are you using ?
@substring I've used a Raspberry Pi 2, today i bought a RPi 3. I will try it again soon.
@Substring I've tried it today with my new RPi 3 but it still says: The --raw option requires a --device.
What should I do now?
Hi received TSOP4838 modules this week, but didn't have time to test.
I'll try it and correct the wiki if needed.
I'll post here once tests done.
Thank you, i have a TSOP4838 too and over a year ago in Recalbox 3.3 it worked with this wiki manual.
Now in Recalbox 4.1 it doesn't work, I hope you find a fix for this problem.
@farbkasten Hi I fixed the wiki, can you retry please ?
@rockaddicted Thank you, now it works but i have another problem.
When i'm finished the recording of all buttons i want to record it says i should press enter to exit but it didn't work.
What am I doing wrong?
Ok so wiki corrected, you can check diff here :
Restart from 0 and tell me if you have a problem
@rockaddicted Same problem again. As i described in my last post it doesn't finish recording when i'm pressing enter.
When i'm pressing enter it just getting downwards, as you can see in the photo above.
@farbkasten I really don't know.
I tried it many times to correct the wiki and take the screenshots, and I didn't have this issue.
Once mapping over, I pressed enter key, and the software asked me to press many time the same button, and that was over.
Did you affect the button to different functions ?
Did you try with an other one remote ?
I have one that get stuck on previous step.