Reset Button Recalbox 8.0.2

[berti2k]

Hi there,
I'm in the process of installing a Pi 3 into an NES case and I can't get the reset button to work. According to the wiki I have entered system.power.switch=PIN56PUSHRESET in the recalbox.conf and connected pins 5 and 6 on the Pi. According to the meter, the pressure switch also works correctly (continuity when pressed).

What is it about the recalbox.conf-pre-8.0.2-Electron? Is there also a change to be made?

Do the GPIOs still have to be activated somehow or are other settings required?

Thanks a lot

[Zing]

@berti2k Read the documentation carefully, there is a configuration for the on/off button, and another for the reset button:

• https://wiki.recalbox.com/en/tutorials/others/add-on-off-button-to-your-recalbox

[berti2k]

@zing
Thanks for the help, I connected the cable properly and it worked.
Is there a way that I can adjust the mapping or is that fixed? How does it look like with two-digit GPIOs? For example, if I want to pin 31 (GPIO 6) because I still need 5 and 6?

[Zing]

@berti2k Sorry, I believe the commands are fixed, not editable. But, I'm not a developer, I can't say that it's impossible, but I can say that it's not something an average user can do.

I don't know what you want to do with the GPIOs, but, see if there's any documentation for that, I know we have something for controllers, for example:
https://wiki.recalbox.com/en/tutorials/controllers/gpio