Recalbox starts on logo screen, then black screen and RPI never turns on again
Hi, i found an old Rpi2 yesterday, which have Recalbox installed (from 2016 or so), then i removed and installed OSMC and used it normally. Then i decided to install emulators again, so i downloaded the latest recalbox pi2 image and flashed it.
But it simply turns on the Logo Screen (Loading Screen) and then goes to black screen, and after that if i turn my pi off and tries to turn it on again, it doesnt even light the lights up. And i have to remove from SD and flash anything else again.
Any help please.
guicln last edited by
Did you try to edit config.txt ? It could be due to a bad boot resolution with your screen.
@hrqmonteiro you probably didn‘t wait enough on first boot for the share partition to be properly created. Re-flash the sd card and wait as long as needed until recalbox boots up. And of course, aleways turn it off safely from the menu.
It stayed on for about 10 minutes, And have you check the part when i wrote that the Pi lights went off? This is the strangest part for me
@guicln I didn't think of that, but i'll check.
@hrqmonteiro I read everything you wrote, yes.