Hi
I want to put Recalbox on the second hard drive. The version for computers (PC 64 bits - x86_64). At boot, I will choose from which disk is loaded.
I have a computer running Windows 10, how can I do it (did not find any descriptions)?
Thank you!
p.s. sorry for my translation
@lrn hi
Using etcher avdanced mode, you can burn the img to a hard drive. Make sure not to erease an unwanted disk
How to burn an image to a hard drive from under Windows 10? All utilities write to flash drive ...
@lrn like @Substring said, use Etcher... in unsafe mode to enable write on hard disk.
What should be done? He does not give you the choice of a drive!
My second disc is divided into two parts - is not that a problem?
Thank you!
@lrn Is your Windows currently using 
or F: drive ?
And where recalbox.img.xz is located ?
Disk D:/
@lrn you can't flash this disk... because the image is on this disk. Put the image on 
@lrn But be carefull, it will erase both and F: !
I have two disks on my laptop.
I want to install the recalc box on the disk F:/
Now he chooses two sections at once
@lrn you can't install on F: only. The installation will erase the whole drive.
Recalbox is an Operating System, which creates its own partitions. That's why you can't install it in an existing partition.
If you put Recalbox, and then Acronis change partitions. Is this possible?
I do not have, not a monitor, no TV. Therefore it is necessary so to get out, without Raspberry Pi!
@lrn you don't have a usb key on which you could burn reclbox and then boot your laptop on it ?
The hard drive is more convenient + 10 places more!
@lrn in this case you have to use the whole hard drive. Currently you can't install Recalbox and keep other partitions.
Thank you for the detailed and fast response!
Question:
Can I change the sound driver? I have a noise after the launch. Noise overlaps the sound (there is sound, but noise is louder). Noise - Pphhhhhhhhhhhh...
Sound card: Realtek ALC269
Hi
I want to put Recalbox on the second hard drive. The version for computers (PC 64 bits - x86_64). At boot, I will choose from which disk is loaded.
I have a computer running Windows 10, how can I do it (did not find any descriptions)?
Thank you!
p.s. sorry for my translation
