After 4.1 update, LED doesn't work, but power button does...

[xtreemsurf]

@azvarel said in After 4.1 update, LED doesn't work, but power button does...:

@xtreemsurf

I have used system.power.switch=PIN356ONOFFRESET without problems, even with cooler fan.

Thanks for this! Do you use a momentary switch with this?

[azvarel]

@xtreemsurf Use, power button, reset, led and cooler

[xtreemsurf]

@azvarel

I use a momentary switch...but this worked! It corrected the LED issue and the momentary switch still functions correctly.

Which pins did you connect your fan to? Thanks!

[azvarel]

@xtreemsurf

pins 4 and 9

[gmgman]

@azvarel you can also use pin 1 and 9 for the fan. I found that if you use one of the 5V Pins the fan is too loud, 3V is way quieter and it's still cooling nicely.

[azvarel]

@gmgman my fan is 5v and is very silent

[azvarel]

I left it running normal, because where I live it is an unbearable heat (it is almost the desert of the Sahara) is the that it gives to live in tropical country.

[xtreemsurf]

@azvarel

When you connect the fan there, does it turn on/off when you use the power button...or does the fan stay running constantly, until you pull the power cord out? Thanks again!

[azvarel]

@xtreemsurf

It stays on even with the rpi in standby, so I put a key behind the SNES to turn it off.

Click #SNESProject on my signature, which you'll see

[xtreemsurf]

@azvarel

Very cool...thanks!