Can't get IPAC 2 to work properly

[voljega]

@nightfall Revert to default configuration with WiniPAC.
(Don't mind the tab about key configuration)
Also be sure to try the two possible names for the empty files.

[Nightfall]

I tried it with the default configuration as well (the only thing I actually had to switch was the hotkey and start for P1) and I also created both empty files. Though none of it worked

[voljega]

@nightfall did you also configure your control in Emulation Station ?

[Nightfall]

Yeah I did. Though if I try to configure it by "Hold a button on the controller" it just says keyboard. So what it ultimately does it overwrites the config if I try to set up both player 1 and 2.

Though even if I configure player 1 (as stated above) it just works inside Emulation Station.

[voljega]

@nightfall hmmm strange, from what I remember I had connected a pad, got to the configuration menu with it and configured the ipac from there, but it is still on a old version of recalbox (pre 4.0)

[Nightfall]

As I said, the pad works perfectly fine. It's just the keyboard encoder that troubles me. And it's driving me insane.

[Nightfall]

So nobody got any more ideas?

[Substring]

@nightfall need a support archive

[Nightfall]

@substring sure thing. I uploaded one at https://www91.zippyshare.com/v/KBRzoos5/file.html

I tried again over the weekend but I can't get it to work. Tried a SNES game for a change but still no luck. Won't respond to any input.
Hope you can help?

[Nightfall]

@substring I take it all back. Finally figured out what was wrong.
Somehow I screwed up the touch and created multiple files which I couldn't delete. Once I cleared the folder and created a new file for me input it finally worked.
Thanks anyway

[Substring]

@nightfall freat ! the wiki is not that bad afterall