Posts made by KwansuDude

I have my rpi3 mounted inside an N64 Case.

I purchased one of these:
https://www.amazon.com/YCS-Basics-Cellphone-Charging-Extension/dp/B00B5HSC20/ref=sr_1_2?ie=UTF8&qid=1474066195&sr=8-2&keywords=micro+usb+extension
to go inside the case and give it a cleaner plug in look on the outside.

Would it be possible to splice this into that extension?:
http://vintagewireandsupply.com/toggle-switch-brass-plated/

Because you can shutdown the system from the ES menu I would just like the ability to switch the rpi3 off without having to unplug it
everytime.

I apologize if this is not the right section for this question but if anyone could help I would appreciate it.

Thanks

The Wiki is not the easiest to navigate for a noob.

Could someone please provide a little easier set of instructions on:

1. Changing the Theme of ES
2. Changing the Order the Emulators show up on ES

Thank you,
KwansuDude

I have managed to get all the systems I want working except for NEO GEO.
I have followed the wiki on this system and even tried the FBA-Libretro method.
I have the Bios Zip where they should be but every time I select a game I goes to a black screen
then returns me to the main emulation station menu.

If anyone could point me in the right direction to get this final system working it would be greatly appreciated.

Thanks,
KwansuDude

@subs haha I got it. Thank you. The adjustment worked perfect!

@subs which direction should i change it?

@nosfay Thank you very much. That did the trick!

Would you happen to have any advice on how to make the joystick more responsive?
I've tried adjusting the analog peak without positive results.

Thanks,
KwansuDude

I have been following the installation instructions religiously.
I have a raspberry Pi 3.
Installed the latest version of Recalbox.
Loaded it full of games.
All systems work flawlessly except the N64.
Probably a noob problem I am having.

I am using original N64 Controllers with the dual mayflash usb adapter. I have been able to run the jstest and figure that out.
I updated the InputAutoCfg.ini with the joystick being called a HuiJia USB GamePad and setting all the buttons properly.

The next step is to edit the Mupen64plus.cfg so the controller configuration mode is set to manual.

when I run
nano /recalbox/configs/mupen64/mupen64plus.cfg
it opens up but it says new file at the bottom and there is nothing there.

If anyone can help or shed some light on my screw up it would be greatly appreciated.

thanks,
KwansuDude