My new arcade machine...not perfect with no super finish touch but it works and to be honest, to be an amateur with not enough tools, i am proud of it. I love recalbox!!!!
@substring hello again, i made them working again. I have changed the advanced emulator options in Libretro i just selected as emu libretro and FBA and auto and in mame i selected advancedmame as emulator. Is that correct? now they all work
@substring yes, that was my last change to see if doing it it will work, but of course it did not. I will revert back to the correct word, but that is not the issue.
does normally works when you use Gparted to extend partitions_
I have used parted to expand my sd card to 64 Gb. I may think this could be the cause but not sure. Everything looks fine except that now no noms work, and they back to emulator when you try to run them. Everything else works as normal.
I have made a backup of the Sd from a working recalbox. I did a restore on another SD card and introduced into a new raspberry. Everything looks fine but when i try to configure the new controller ( a USB DIY joystick), when i go to the right move, it say Already taken. The rest looks fine and also the second joystick as well. When recalbox start, if i move right with that joystick it will loop moving it until i click on Up or Down.
I have changed the cable from that right conexión into the board and also i have changed a new board. The same issue.
thanks for your help