@zing My bad! Your resources already contained the solution. Thank you!

@zing My bad! Your resources already contained the solution. Thank you!

@zing Alright, I'll check it again. Thank you!

@marcus1966 network settings, enable wifi, select ssid, enter password, done

@zing Unfortuantely all your links refer to topics on "how to configure controller a,b,c for n64 games". I know how to do it for both the standalone and the libretro emulators. My problem is that I cannot change the hotkey combinations for the standalone emulator and be able to also use the libretro emulator.

Adding the line "n64.configfile=dummy" into my recalbox.conf has the result that retroarch don't recognize my previous used usb controller anymore.

Do I miss something?

@zing Thanks, I'll check the references and will present my findings later

Hey,

I'm very glad that the mupen64plus standalone emulators are back for the recalbox. Unfortunately I tackled an issue...

I would like to change my hotkeys for this emulator using the \recalbox\share\system\configs\mupen64\mupen64plus.cfg file.
Everytime I start the emulator the settings changes back to the original ones.

I figured out one possible solution which is to add the line "n64.configfile=dummy" into the \recalbox\share\system\recalbox.conf file.
However, with this change everytime I start the libretro emulator it says "failed saving config to dummy" and I'm not able to to any inputs.

So with this solution I can have my preferred settings in either the standalone or the libretro emulator. Of course I would like to have them using both

I know in retropie there is a file /opt/retropie/configs/all/autoconf.cfg in which I have to chnage the value for "mupen64plus_hotkeys" in order to keep my hotkey changes in the mupen64plus.cfg file. But using recalbox I wasn't able to find this file yet.

Does anyone have a clue for a solution of my problem?

Btw. I also have the same problem with the retroarchcustom.cfg. All changes I do there (e.g. for setting different hotkey combos) won't be kept as well.

Thanks in advance!

Thank you!

Hey everyone,

can someone please tell me the exact overlocking settings for the extreme option on a raspberry pi 4?
Are there more changes than over_voltage, arm_freq and gpu_freq?

Thanks in advance!

@clkgames Awesome thanks!

btw, I'm using the current version of recalbox (7.2.1 Reloaded) with a raspberry pi 4b