Recalbox with illuminated Start/Stop Button
-
Hello from Germany!
Inspired by @Colonel69 's design, I created a little Recalbox based on a oneninedesign case myself.
Please note that I cannot recommend this build. I had to remove some GPIO pins (and even had to cut into the black plastics that is holding the pins o_O).
Otherwise, the case looks great and I only hope that my soldering skills were good enough that the resistor (LED) and cables will stick to the switch (which is momentary, btw).
Thanks for the great software!
René
-
Great project!!
What is the reference for the button??
-
http://www.ebay.de/itm/282268387843 (Germany only)
12 mm momentary switch with integrated LED (blue), 3,3 V 15 mA, I myself used a 62 Ohm resistor for less brightness.
-
Good job @hanker !
I had hesitated with this type of button but I didn't see where to place it in the case ! XD
++