Recalbox with illuminated Start/Stop Button

[hanker]

Hello from Germany!

Inspired by @Colonel69 's design, I created a little Recalbox based on a oneninedesign case myself.

Please note that I cannot recommend this build. I had to remove some GPIO pins (and even had to cut into the black plastics that is holding the pins o_O).

Otherwise, the case looks great and I only hope that my soldering skills were good enough that the resistor (LED) and cables will stick to the switch (which is momentary, btw).

Thanks for the great software!

René

[zico92]

Great project!!

What is the reference for the button??

[hanker]

http://www.ebay.de/itm/282268387843 (Germany only)

12 mm momentary switch with integrated LED (blue), 3,3 V 15 mA, I myself used a 62 Ohm resistor for less brightness.

[Colonel-v4]

Good job @hanker !

I had hesitated with this type of button but I didn't see where to place it in the case ! XD

++