Solved Games load very slow Dragonblaze 6.1

[Scavy]

Hi @styrkjar
The bluetooth module is currently updating by @OyyoDams, it may solve your problem. It will be included in the coming-soon recalbox release, v6.1.1.
Your controllers are 8bitdo, which modeles ?

[Styrkjar]

@scavy I'm using the SF30 Pro
I haven't tested other BT-Controllers yet. I'm just wondering if I'm the only one with these issue...

[Scavy]

@styrkjar I'm using the same controller as yours. I don't have this issue. Is your controller connected in Android mode ?

[Scavy]

@scavy said in Games load very slow Dragonblaze 6.1:

@styrkjar I'm using the same controller as yours. I don't have this issue. Is your controller connected in Android mode ?

I'm also using PS3 and PS4 official controllers, it works fine also with the BT mode.

[pmroyo]

Hi @styrkjar.
I have the same issue with my SN30 PRO. No problem with a generic USB gamepad but when using SN30 pro it takes more than 30 secs loading the game. I am charging my 8bitdo ZERO in order to test, will come to you with the results

[acris]

8 Bitdo need to use D-input not x-input
with x-input mode -> slow

[Styrkjar]

I ised the 8bitdo Controller for quite a time without any issues. This started suddenly, after reconnecting it.
Maybe it's just a faulty device, bit even then, the Bug is quite strange...

[pmroyo]

@acris I have always used X-input and no problem at all until this new version of recalbox. D-input is for android according to the manual

[acris]

@pmroyo
lot of change in new version of recalbox

Please use D-input , configure gamepad, and try again.

[Scavy]

@pmroyo said in Games load very slow Dragonblaze 6.1:

D-input is for android according to the manual

You have to use the Android mode for RCB (D-input). I'm using this one according since i got my controllers (and snice the 4.1 release), it works perfectly (no BT disconnection and no lag).
And as @acris said, don't forget to configure your controller.

[pmroyo]

Thanks guys, I have change the pair mode to android in my 8bitdo ZERO and SN30 PRO and the issue has been solved.

[Styrkjar]

Thanks a lot. This solved the Problem.