Hello,

I have Recalbox running on a Raspberry Pi 3. Everything is working pretty well. I would however like to get the ZX Spectrum emulation working. I can launch games and they start fine, but none of the input methods are working well enough to actually start a game. It appears as though Q and W are the only keys working as Enter and Space from the keyboard. I also have a couple of clone (SZMY-POWER) PS3 Bluetooth controllers working on the internal Pi3 Bluetooth using the official driver. But these do not work in the ZX Spectrum emulator except for the Select button that brings up the on-screen keyboard.

Is there anyway to "simply" use the full keyboard in the ZX Emulator?

Thanks

Trevor.

I have the same N64 issue with 17.12.02 using the Pi3 (no overclock) and the internal Bluetooth controller.

FYI, it took me a while to get my SZMY-POWER clone controllers to work.

I had the driver initially set to Official and they would pair, but no buttons would work. So reset the controllers and cleared the Bluetooth controllers from Recalbox. I then tried the Bluez driver and again they would pair, but no buttons world work. I then changed the driver back to Official, rebooted my Pi3, turned the controller on, it connected, but no buttons working again. I then connected the controller(s) via usb again, waited 20 seconds, disconnected (like I was pairing them again, but I had not reset them or cleared the Bluetooth controllers from Recalbox) and they are now working over Bluetooth (with a little bit of lag, but still playable ).

For piece of mind, I created a new SD Card with clean Recalbox 17.12.02, and went through the process again. Same issue. Official would not work initially, neither would any of the other drivers. I had to set to Bluez, pair via usb, change to official, pair again and everything works.

Hello,

I have Recalbox running on a Raspberry Pi 3. Everything is working pretty well. I would however like to get the ZX Spectrum emulation working. I can launch games and they start fine, but none of the input methods are working well enough to actually start a game. It appears as though Q and W are the only keys working as Enter and Space from the keyboard. I also have a couple of clone (SZMY-POWER) PS3 Bluetooth controllers working on the internal Pi3 Bluetooth using the official driver. But these do not work in the ZX Spectrum emulator except for the Select button that brings up the on-screen keyboard.

Is there anyway to "simply" use the full keyboard in the ZX Emulator?

Thanks

Trevor.