@souzafl said in Nintendo switch pro controller vs Recalbox 8.1:
@aldébaran Friend thank you so much for replying! Really the command works, but only when I hold the "L + R" before the boot screen, if you don't press the combination it is recognized as "Zhixu Gamepad". In version 8.0.2 the controller was recognized as Nintendo Switch after the entire update process was completed, and then pressing the "L + R" combination the controller assumed as Nintendo Switch.
Could you tell me where I can change this process of recognizing/initiating the control, so that it accepts the combination "L + R", after the entire initialization process is completed?
Friend found the solution: I analyzed the boot order in the boot.list file, and found differences between version 8.0.2 and 8.1. As I did a clean installation of version 8.1 on another card, I replaced this file from 8.0.2 in version 8.1, and with that I returned to the condition I needed: to recognize the control only after the entire system initialization process, and with the combination of the "L + R" buttons, it is possible to activate the control.