SOLUTION:
For some reason I had ";" showing before the words system.externalscreen.
By removing these I was able to get it on a secondary screen.
system.externalscreen.prefered=HDMI2
system.externalscreen.forceresolution=1920x1080
Thanks a bunch!
I have figured it out and its working now.
I will post the solution later or rather what was wrong
@Zing First of all, thank you very much for your swift response.
I must say that you guys did an amazing job with recalbox.
I tried as you suggested and managed to find the names. I tried it first via VGA1 connected with VGA cable to external screen.
I booted the computer and closed the laptop screen. It was showing everything else on the external monitor but it eventually moved back to the laptop screen. The external monitor showed "no signal"
The same went for my tv. The recalbox showed that it was connected to HDMI1. I adjusted the config file and rebooted.
Then same as above and eventually no signal on TV screen.
Any thoughts?
I have gone to share\system\Recalbox. conf and edited as follow:
;system.externalscreen.prefered=HDMI1
;system.externalscreen.forceresolution=1920x1080
Hi all,
I had a look at this article.
Re: Recalbox 7 laptop switch external screen function x86_64
I tried editing the file on windows10 computer.
I entered several options where it shows HDMI2 below. I tried HDMI, HDMI1 (Using HDMI cable) and VGA (using VGA cable)
system.externalscreen.prefered=HDMI2
system.externalscreen.forceresolution=1920x1080
I get the boot bit of recal showing on external screen but then I see "No signal" and then the screen on my laptop screen shows the recalbox.
Any help would be much appreciated.
Thank you.