Awesome!

I am, by coincidence, running Recalbox on the Raspberry Pi 4. It works like a charm. Trying to tweak N64 games a bit, I came back here and was surprised to see, that the Pi4 is not officially supported...

It seems that even though it is not supported, it does work. I have not encountered any issues so far.

I will provide some photos later this day.

The weird problem came from not enough current. I switched the power source and then everything went fine. Though the Pizero is highly not recommended for any Recalbox project. The menu is very, sluggish if the output is an average Hdmi monitor with 720p. The pizero should only be used for handheld tft displays with lower resolutions. Then it works fine. I think I will do a Gameboy Hack, if I find one. Or maybe use an old nes controller.

Awesome!

Hi there, I am doing a new thread, because the issue doesn´t seem to have appeared yet. This is my setup:

• PiZero
• Powered USB Hub D-Link
• Wifi Dongle from PiHut
• compatible Bluetooth Dongle from CSL.

I have downloaded Recalbox 4.0 stable, then I powered up my PiZero. At the boot screen it freezes. If I plug in a keyboard however, it starts normally. Bluetooth and WLAN are working, but if I use the webinterface to copy roms, it is verry slugish and in 9 from 10 tries, the rom upload aborts.
Restarting the Recalbox ends in freezing againl, unless I plug in a keyboard... .

I have tried to use an unpowered USB Hub, as well as none at all. Without the keyboard it is not working... .

@Seramis D**ned, I am stupid... I downloaded the beta instead of the stable Github Version. Guess this must be it.

@Seramis Ok this is weird. Recalbox only starts when a keyboard is enabled, even though I have a Bluetooth Controller working that fits perfectly for controlling the overlay. No Keyboard, no Recalbox on Pizero. Any ideas?

@Seramis Solved it myself. The issue was soley usb port related. The Pizero doesn not seem to like two devices capable of giving power output. I have used a china hub without energy and it works well. Curious thing though.

Ok then, my Pizero has arrived and Kano works like a charm. I have just tested my recalbox build but the software doesn´t start. It hangs on the boot screen forever. So I started fresh and got myself the image from Github, erased my sd card with the formater and placed everything inside. However the Pizero still hangs at the bootscreen.

If I put the very same imgae in my pi3 it works. What´s wrong?

Ok here is another thing I need a display capable of displaying 1024768 or higher. It should be cheap. Unfortunately there are only 1024600 devices out there. Touch would be nice but is not Obligatory.

@Substring I did. I thought about such a thing. Then it is ok I guess.