Disable state and network interface LEDs
Is it possible to disable all onboard-LEDs of Pi3? The continuous blinking on TV-stand is quite annoying for me...
Maybe some shell command or config file entry to get rid of it?
Would be fine if there is a solution, instead of pasting a tape on :)
Many thanks in advance for your answers!
@lhari84 get a box ?
@lhari84 Errrr ... you can eventually change the PWR and ACT leds behaviour (but it's rather complicated), but I know nothing regarding the LAN.
My advice : put some black tape :D
This is the answer I was afraid of :D
Ok, so the good old tape...
@lhari84 I do have other ideas, though i don't know the english for it ... What ladies put on their nails ? I hope your girlfriend/wife/life partner is gothic ;)
Unfortunately she isn't gothic. But I prefer the tape anyway, I think it's easier to remove ;)
I have the original Pi-box, because I like the design. As most other boxes (?) it has holes to show the state LEDs and also LAN port is not covered where the LEDs are placed.