Problem with GPIO

[darth]

Hello team, how are you doing?

I installed the new recalbox 7.1.1 RELOADED.

I have a portable case (GAME HAT),

The manufacturer indications to make it work through GPIO is the following:

on recalbox.conf edit this:

controllers.gpio.enabled=1 (change 0 to 1)

and this:

##controller.gpio.args=map=1,2
controllers.gpio.args=map=5 gpio=5,6,13,19,21,4,26,12,23,20,16,18,-1

I have been using this on recalbox 6.1.1, with this exact configuration and worked good, but when I tried this on 7.1.1 it does not work.

Any ideas? Thank you

[darth]

I forgot to add that I am using Raspberry Pi 3b+

[ian57]

@darth said in Problem with GPIO:

I forgot to add that I am using Raspberry Pi 3b+

that's really strange, there's normally no problem and it was tested

Can you send an archive support please.

[darth]

Thank you for the response, I did a new clean install and it worked.

Something went wrong during the migration from 6.11 to 7.1.1

Thanks.