Unplugging controller to get it to work in ES and retroarch
-
@bizmoan said in Unplugging controller to get it to work in ES and retroarch:
My ps4 controller is hooked up through usb as i have a pi 3 that does not have bluetooth
Except if yours is broken, this doesn't exist. Or this is a Pi2.
What is the usb board / controller used in your arcade stick ? Or the model of it ?
Did you configure controls mapping in EmulationStation ?
-
Im sorry it does have bluetooth dont know what i was thinking.
I did map it out in emulationstation.
My arcade stick is a pandora box arcade stick with usb 2.0. seen here
https://www.aliexpress.com/item/2-Players-PC-mental-Arcade-Joystick-Control-panel-arcade-game-console-999-1299-1388-2020-in/32940730588.html?spm=a2g0s.9042311.0.0.5bec4c4dlcAEWFI only ventured to recalbox cause after i bought this thing the software crapped out on me after a week, and couldnt return it as it would cost just as much as i bought it. thank you for replying ,
-
@bizmoan hmmm I suppose you plug the original device directly to your tv through HDMI or how does it work ?
There is also an USB ouput ? (single one I suppose)
-
Yes through my hdmi tv . there is two usb on the arcade stick and 3 on my tv. is that what you meant?
-
@bizmoan yes, so you can plug this device with the usb ouput on a pc or ps4 to use it just as a joystick ?
Is there one usb ouput for each player or the two ouput each connects the two players ?
-
there is one usb output for the dual arcade stick. 2 sticks one usb. recalbox recognizes them as 0-ps3/pc and 1-ps3/pc something like that
-
@bizmoan ok so if you try to mp both controler in Emukation Station do you manage to map correctiy all buttons and directions ?
-
yes everything is mapped out properly.
-
@bizmoan hmmm pretty strange then, maybe you messed up something in retroarch menu ?
Can you make a support archive through the recalbox web manager ?
-
how do i do that?
-
yes i will do that when i get home.
-
update, I spent so many hours prior to this post to try to figure it out. Im knowledge of run command and programming is very limited that i ended up trying something different and using the gpio pin from the rasperri pi and connected my arcade stick that way. I made sure to write down where everythings went jus incase it didnt work. I did the first player and got the arcade stick to work after enabling gpio in web manager. I still would love to know what is wrong but i assume at this point its to late create a support archive, thanks for the help to all.
-
@bizmoan if it works that way it's cool anyway
Nd it might be better if you decide to mod the joystick or buttons later
