Hello Dev team !

I'm running the 11/29 beta on my Pi3B+ and so far it's working great except the wifi that is still very buggy (unable to connect) so I keep it on ethernet.
FYI, there is an upgrade available notifications that pops up (I'm configured on the beta channel) but when I try to apply it I get the following error message : "An error occured - Downloaded : " without any download.

I'll try later on to see if this could be a temporary issue with the servers.

Keep up the good job and thanks a lot for all your efforts into this !

@oyyodams Hello la team et merci pour votre travail !
Je viens de flasher une carte fraiche sur ce nouveau build de beta 2018/11/12 pour tester le wifi. Problème toujours présent pour moi : une fois que je l'active, je sélectionne mon SSID et je tape mon MDP mais impossible de se connecter.
J'ai aussi essayé en mettant directement les infos dans le recalbox.conf mais j'ai le même résultat. Du coup, je suis revenu en cable.

Hello,

I downloaded and installed the beta2 image on a fresh SD, mapped my Xbox 360 pad (wired) and configured the wifi.
Couple of observations :

• the wifi connection is unstable. Sometimes it can't connect to my box (freebox) and sometimes it "loose" the connectivity : it's kinda frozen and then unfreeze after 10 or 20 seconds. (my wifi connection was working fine with pi3)
• the wired connection via ethernet is stable
• via the windows 10 file explorer, when I try to access \recalbox (or directly the ip \192.168.0.44), the folder list is empty. It doesn't show me the share & roms folders
• I can access http://recalbox via my browser but I can upload only small files into the rom folders, so when I try to upload big roms via a sftp connection (client = WinSCP), the upload fails randomly (sftp error, bad packet), both in ethernet and wifi connection.
• Clock speed : it shows 1200 MHz and not 1400 MHz as expected
• Memory : it shows a total of 495 MB instead of 1 GB of RAM

Next round : I'll test some emulators.