@Substring when I save or load a state, I only see square at the bottom of the screen. Can't read the text

Great work by the way! Keep it up

@Substring can't reach recalbox manager. Tried to set it both to 1 or 2 in recalbox.conf but get an error message when trying to connect to the IP address of my raspberry

I don’t use Kodi at all...

My controller works after I remapped R2.

I still can’t connect to WiFi though

Had the same trouble with my original PS3 controller. But could go back up to the R2 button in the list and re-assign it.

I also can’t get WiFi to work. If I enter ssid and the password the system hangs up when I leave the menu

Raspberry 3, not plus

@Coke84 Danke. Jetzt sollte man nur noch wissen, was das zu bedeuten hat

@Substring is the update issue fixed in the latest .img? You mentioned extending / to 2GB.

@Coke84 maybe you can check this for us

Frage zum DS4 support: Wird das Touchpad unterstützt? Wäre cool das als Mouse Ersatz zu nutzen...

Not a bug, but a question regarding PlayStation DS4 support: Is the touchpad area supported? As mouse? That would be cool

@Substring umm, yes... didn't think that would be an issue

So should I rather install 4.0.1 and update from there?

Another issue I ran into: I can't update. The system always tells me there is an update. Then I start the update... After a while I'm asked to reboot. When I reboot, I see the startscreen, then the installation doesn't happen. Instead, it restarts, and I end up in the same version (with the popup mentioning there's an update available).

I see a horizontal 1 pixel line flashing up during that intro animation. during the rotation. pretty much in the middle of the screen.