Guys i need help.
I want to configure a GPIO controller but recalbox just doesn't pick it up right.
Basically i have this snes controller with a raspberry pi zero w inside, and the buttons are wired through gpio. Using retopie it works fine cause i have a scrip for it to work. But im not stisfied with retopie and want to try recalbox.
These are my gpio wiring
I have activated gpio controllers in the .conf, but it sees the controller seperratly. If I activate only 1 controller it sees only the the LEFT and UP button as controller one. And it thinks it has a second gpio controller connect and pick up START, SELECT, A, B, Y, X, L and R as it.
DOWN and RIGHT buttons are just not pick up
i have tried setting "controllers.gpio.args=map=1 gpio=28,15,16,27,32,29,36,31,38,35,37,40,-1"
but it still doesnt change anything. Player one still only gets LEFT and UP
have also tried "controllers.gpio.args=map=1 gpio=gpio1,gpio22,gpio23,gpio0,gpio12,gpio5,gpio16,gpio6,gpio20,gpio19,gpio26,gpio21,-1"
but this one the controller is not even recognized anymore
what should i do?
In case ur wondering this is how it looks like on the board
