Posts made by j0taele

@paradadf finalmente era por la controladora USB, efectivamente parece que mandaba señales erróneas. He soldado el cableado de otra manera y ahora ya funciona sin problemas. Muchas gracias cierro el hilo como solucionado

Perdonad, no me había dado cuenta que estaba en el foro español XD

Vuelvo a plantear mi problema:

Estoy usando la última versión de recalbox en una Raspberry Pi 3 con mandos de arcade conectados a controladoras USB y estas a su vez, conectadas a las Raspberry.

Tengo 8 botones, los cuales los configuro como A, B, X, Y, L, R, START, SELECT y HOTKEY (estos dos últimosjuntos en el mismo botón). Con esta configuración, cuando entro en un juego y le doy al botón que tengo asignado como START el sistema se sale y vuelve al menú de Emule Station. Sin embargo, si no configuro este botón, perdiendo uno y el SELECT / HOTKEY lo asigno a otro botón, entonces si funciona,

¿Alguien sabe por qué me puede estar pasando esto?

Saludos!!!

Hello to all,

I'm using the last version of recalbox with rpi 3 and arcade pads.

I have 8 buttons so I configured A, B, X, Y, L, R, START, (SELECT, HOTKEY in the last button). With this configuration the system exits from games only pressing start button. However seems how hotkey button is not working.

regards and thank you

@neb said in System exits from emulestation only pressing START:

@j0taele
Are you sure your button (the one you want to assign to Select and Hotkey) works ?
Because if select/hotkey works with another button, it looks like your button is not working properly.
Did you try to assign this button to another command ? (like assigning it to A and then try if it works...)
Or maybe you should check your GPIO inputs ? are you sure you used the correct pin for your button ? (they are really near to each other). I had a similar problem where one of my buttons didn't work and it appeared i had not used the correct pin on the GPIO.

Hello @neb I have connected the buttons to a USB controller, I don't use the GPIO pins.

When I configure the buttons I press the button and the system detect it so it seems to works. But tomorrow I try changing with another button. Anyway, don't you seem strange that I can exits only pressing one button (start)? I don't understand.

Hello acris, Thanks for your quick reply.

I have tried to remapp a lot of times with the same result. However, if I don't map one button (the button I lke for select and hotkey) and map other button (e.g which was previously L) for select and hotkey. Then works and exit emulestation with hotkey + Start. But is not the button map I like.

I do not understand why this is happening. I have read the manual and forums but I have not found anything. Is it possible to modify it manually in a configuration file?

Thanks for support

Hello to all,

I'm using the last version of recalbox with rpi 3 and arcade pads.

I have 8 buttons so I configured A, B, X, Y, L, R, START, (SELECT, HOTKEY in the last button). With this configuration the system exits from games only pressing start button. However seems how hotkey button is not working.

regards and thank you