@voljega ok perfect. What should I add or change to it. I didn’t see anything that said overclocking

@voljega I would also like to say I would prefer to edit manually by removing the usb or as card and working on my computer. I’m not familiar with ssh at all.

@voljega so here’s he tricky part. I’m running it off a usb. If I take the usb out and look at it. There is no config file. On the as card there is but I’m not sure what I’m looking for.

Further if I choose to run off of internal storage instead of my usb it all works it just doesn’t have any rims and kodi isn’t set up. It’s essential stock. So I’m not sure editing the config file on the as card would help.

If I edit it via ssh will it edit the active storage ?

@voljega so after some research I am fairly sure it’s because the overclocking won’t reset back to normal. I’ve tried holding down shift in restart to reset everything but it doesn’t work. Anybody have any ideas?

@voljega I can’t get into kodi to remove the build. A build is essentially just a preconfigured set of addons and skins for kodi.

@voljega I should add I tried to overclock it to high. Just to see if it would improve kodi performance. Now it won’t let me change it back to normal. It reboots after I change it back but when I check it is always on high again

@voljega ok I am fine with just kodi working until my adapter comes in. I am connected to the tv with hdmi. Kodi was working and I was able to put a build on it earlier and everything.

I am new to recalbox. I have an rpi3 and a lot of games as well as kodi set up. I set it all up and then configured the buttons on the keyboard I’m using. Now if I open a game or kodi the screen goes black for a few seconds and then takes me right back to the last screen I was at in recalbox. Any ideas?

Thanks for any help in advanced.