Posts made by AetherDrive

Hi Everyone!

I have received my Recalbox RGB Dual HAT and when I plug it in it causes it to boot for about 2 seconds and then turns off. I am using the Argon One M.2 case and have a Canakit PSU. Ive read the manual and set the correct settings and correct orientation as described with the argon one m.2. I’ve tried booting without the M.2 connected as well as all peripherals and it still has the same behavior. When I tried a PHAT Board and put it in a lower slot, I got an extra second of boot time before it crashed. All of this would suggest that I perhaps got a faulty board or something akin to this. Also, as a side, my Recalbox won’t normally boot without the RGB Dual as it’ll hang in the boot screen now, this wasn’t the behavior beforehand . I’ll be creating a new boot image tonight but are there any other suggestions or ideas as to what could be happening?

Thank you for the reply, I did look at that device before posting however I am looking for a line-out or a line-level device as I have both a stereo amplifier and a headphone amp.

A headphone amp/DAC wouldn't be undesirable either in that sense as that signal can be taken as line-level as well

Sorry, meant a USB DAC

Hello Everyone, I just backed the RGB Dual and am preparing to setup a Raspberry Pi 4B with Recalbox 8. I'll be using the VGA output and so I can't utilize the onboard audio with the unit, I could use the pi's audio out but would prefer not to.

Are there any usb audio sticks that the community recommends that is plug and play or plug and play with a little effort?

Sorry if this is in the wrong section btw