XBOX360 Wireless Controllers not working normally after update

[MarcWilmots]

Since the Update my wireless XBOX360 Controllers are not working normally.
I cannot use the sticks or cross to go left, right, up or down.
Only two buttons seem to have an effect.
A clean installation hasn't helped.
Before the update i was able to activate an xbox driver. This option seems to be gone now.
Does anyone have an idea how to fix this?
(The green light on the XBOX360 controller receiver is on. The controllers are connected. System is a Raspberry Pi 3)

[rockaddicted]

map your controller in emulationstation options menu

[MarcWilmots]

@rockaddicted That helped. Thank you

[elvizius]

Excuse me but, from the update 17 the configuration for the gamepad xbox 360 is disabled. I changed the configuration of the gamepad ps3 to 0, but I can not activate the gamepad 360. I show you the configuration of my recallbox.conf:

-------------- D - Controllers -----------------

Enable support for standard bluetooth controllers

controllers.bluetooth.enabled=1

Please enable only one of these

-------------- D1 - PS3 Controllers ------------

##Enable PS3 controllers support
controllers.ps3.enabled=0

Choose a driver between bluez, official and shanwan

bluez -> bluez 5 + kernel drivers, support official and shanwan sisaxis

official -> sixad drivers, support official and gasia sisaxis

shanwan -> shanwan drivers, support official and shanwan sisaxis

controllers.ps3.driver=bluez

------------ D2 - GPIO Controllers ------------

GPIO Controllers

enable controllers on GPIO with mk_arcarde_joystick_rpi (0,1)

controllers.gpio.enabled=0

mk_gpio arguments, map=1 for one controller, map=1,2 for 2 (map=1,map=1,2)

controllers.gpio.args=map=1,2

Look?Where is the config for the xbox 360?