XINMOTEK XM-10 is not controlled by 1P and 2P.

[rizzie]

Hello~ I use a nice recall box. I tried to apply XM-10, and it works well when 1P is set as controller. However if 2P is set, then 1P key does not work normally. Below is information about the joystick obtained with cat/proc/bus/input/devices.

I: Bus=0003 Vendor=16c0 Product=05e1 Version=0110
N: Name="xin-mo.com Xinmotek Controller"
P: Phys=usb-0000:00:14.0-7/input0
S: Sysfs=/devices/pci0000:00/0000:00:14.0/usb1/1-7/1-7:1.0/0003:16C0:05E1.0002/input/input6
U: Uniq=
H: Handlers=event4 js0
B: PROP=0
B: EV=1b
B: KEY=7fff00000000 0 0 0 0
B: ABS=30003
B: MSC=10

I: Bus=0003 Vendor=16c0 Product=05e1 Version=0110
N: Name="xin-mo.com Xinmotek Controller"
P: Phys=usb-0000:00:14.0-7/input0
S: Sysfs=/devices/pci0000:00/0000:00:14.0/usb1/1-7/1-7:1.0/0003:16C0:05E1.0002/input/input7
U: Uniq=
H: Handlers=event5 js1
B: PROP=0
B: EV=1b
B: KEY=1fff00000000 0 0 0 0
B: ABS=30003
B: MSC=10

How can I use this information to make sure that both 1P and 2P can work properly?
Thank you in advance, sorry for my English.

[joss_baumont]

Try to remap 1P only. The two players should work properly.

[rizzie]

@joss_baumont Thanks a lot. It's very well working.