Hello!
I missed the kickstarter but I might be interested in purchasing the RGB Dual when it hits retail.
What I was wondering is if the VGA output is able to be converted to component video (ypbpr) for NTSC consumer TVs. That would require sync on green and a few other things.
I ask because my setup uses all component and composite video as American sets didn't have RGB.
Thanks!
@gnubit I ended up with a few minutes before work. Your instructions had my problem fixed within five minutes. Cheers!
@gnubit Thanks! I work all day today but I will follow your instructions tomorrow and see if I can get it working. I appreciate your time.
Thank you for the quick response. So, there is currently no way for me to change the resolution or were you saying there is a way to do it manually? I'm not a linux expert, but I'm pretty good at following instructions if there is a way. Thanks again.
Hello,
I am running the latest stable release of recalbox on a 7th generation Intel NUC x86 64bit. Recalbox is installed directly on the hard drive.
My issue is that I am using a 4k TV via HDMI and that is too much for my system to handle. I was going to edit the conf file and add hdmi_group=1 and hdmi_mode=16 to get a permanent 1080p resolution.
However, I cannot changed the conf file because it says the file system is read only. I have tried manually using nano over ssh on my Windows computer, but still no luck.
How can I scale back the resolution?