I have just installed debian and recalbox , on pi 3 . As the debian boots correctly , recalbox doesnt boot at all and my monitor goes off while it boots , it means it gets no sygnal .
What should i do
Bellow my configs :
recalbox-boot.conf:
sharedevice=INTERNAL
global.videomode=default
config.txt:
uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
disable_overscan=1
uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
comment to get jack audio
#hdmi_drive=2
Using /etc/modules is deprecated and no longer supported on 4.4 kernel
So manually enable audio
dtparam=audio=on
config_hdmi_boost=0
force hdmi while the tv can take time before sending the signal on the hdmi output
#hdmi_force_hotplug=1
uncomment for composite PAL
#sdtv_mode=2
uncomment for lirc-rpi
#dtoverlay=lirc-rpi
if you plug your tv at the same time as your rpi and that the rpi switches from the hdmi or give a low resolution because tv had no enough time to initialize it
boot_delay=3
uncomment if you don't want the rainbow at startup
disable_splash=1
Overclock
gpu_mem_256=128
gpu_mem_512=256
gpu_mem_1024=512
#avoid_safe_mode=1
disable_overscan=0
overscan_scale=1
sdtv_mode=2
hdmi_group=1
hdmi_mode=16
any suggestions ?
