Subcategories

• Recalbox General

  Questions about everything Recalbox related, which does not fit into the other categories

  4364
  Topics
  21942
  Posts

  

  @FredMGarcia said in Recalbox 9.2.3 can't change resolution (slow on 4K tv ):

  @adam0509 said in Recalbox 9.2.3 can't change resolution (slow on 4K tv ):

  is it the only way to modify recalbox.conf now ?

  https://wiki.recalbox.com/en/tutorials/video/display-configuration/complete-video-configuration-guide gunspin

  Yes, I tried it and it worked, and here's how you can modify recalbox.conf
  You should try them now because I have done them successfully.

• GamePad/GPIO/USB encoder

  Ask your questions about GamePads, GPIO and USB Encoders in here

  1113
  Topics
  5226
  Posts

  

  Hello, I tried to configure the two Joy-Cons in combined mode, as shown in the guide. The Joy-Cons work fine in the menu, but when I launch a game, the buttons respond erratically — they register maybe 1 out of every 10 presses.
  However, if I connect just one Joy-Con in horizontal mode, everything works perfectly.

  I have the impression that when connecting in combined mode, there’s interference, as if the system sees three controllers: left, right, and combined. In fact, under Controller Settings I can see 3 inputs: left Joy-Con, right Joy-Con, and the combined one.

  I’m not sure if that’s the actual issue or something else.
  Has anyone managed to use the combined mode properly?
  Any help would be appreciated. Thanks in advance!
  Raspberry pi4

• MediaCenter & Dualboot

  Everything related to the MediaCenter and Dualboot setups should be asked in here

  166
  Topics
  848
  Posts

  

  you cannot change Boot order from Recalbox OS; raspi-config is not implemented.

  all changes in config.txt file will be overwritten at next reboot.

  you need to boot Raspberry OS on SD card to update firmware and modify Boot order with raspi-config

  sudo apt update sudo apt full-upgrade

  sudo rpi-eeprom-update

  sudo raspi-config

  Advanced Options --> Boot Order

  SD Card Boot NVMe/USB Boot Network Boot

  I am not sure you can boot USB before NVMe

• Emulator Arcade/PC/Console

  Problems with an Emulator, or a specific game for a specific system, should be reported in here

  1473
  Topics
  7308
  Posts

  

  Hi everybody,
  I am running recalbox on a Raspberry Pi5. I added some ROMs by copying them to the n64 folder via SSH, and they work fine. But if I repeat this procedure a second time to add new games, then every game stops working and after failing to start shows a message that says that the file is corrupted.
  Am I doing something wrong? What is the correct procedure to add new games?
  Thank you